4x4Wire

About you, your 4x4 and access
John Stewart

Replacing Worn Seatbelts

b2ap3_thumbnail_seat-belt-extender.jpgSeat belts have been around since the front lap belt was required on 1965 and new vehicles with front shoulder and rear lap belts appearing in 1968.  The traditional 3-point front belt became standard in 1974. One of the more important pieces of safety equipment in an off-road vehicle is the seat belt.

Continue reading
  16185 Hits
John Stewart

ATS Stabilizer Install

b2ap3_thumbnail_Fox-ATS-Stabilizer.jpgThe 4x4Wire JK recently underwent a slight transformation - from stock to gears, lockers, and lift. That change included new (larger) tires.  And, that resulted in a “bump steer” issue that has now been corrected.

The ultimate solution is the ATS Stabilizer from Fox.  While the Fox ATS Stabilizer is designed to be a direct replacement with a factory suspension, the 4x4Wire JK does have an aftermarket suspension which does entail a little more than just bolting it on.  Installation was quick with little in the way of problems.

Continue reading
  21844 Hits
John Stewart

Looking out the rear view mirror

b2ap3_thumbnail_yj-mirror.jpgThe Jeep is 1994 vintage and does show signs of many a mile.  While '94 is young for a Jeep, there are many things that do wear.  One such item has become an annoyance and needed attention - rear view mirrors.  The stock Jeep mirrors are on swivel ball joints.  Over time, these have loosened to the point they do not stay in position.

Continue reading
  17410 Hits
John Stewart

Steering - bump steer after a lift

The 4x4Wire JK recently underwent a slight transformation - from stock to gears, lockers, and lift. That change included new (larger) tires. But, that change did not include replacing the steering damper. Extended road driving pointed out the need to upgrade the steering damper in order to reduce vibration caused by the larger tires on certain sections of road.

Continue reading
  27171 Hits
John Stewart

Steering - bump steer after a lift

The 4x4Wire JK recently underwent a slight transformation - from stock to gears, lockers, and lift. That change included new (larger) tires. But, that change did not include replacing the steering damper. Extended road driving pointed out the need to upgrade the steering damper in order to reduce vibration caused by the larger tires on certain sections of road.

Continue reading
  4923 Hits
4x4Wire.com

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting. Copyright (c) 1999-2020 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission. You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material. All corporate trademarks are the property of their respective owners.